• If you are citizen of an European Union member nation, you may not use this service unless you are at least 16 years old.

View
 

Newton 2 as a stepping rule

Page history last edited by Joe Redish 12 years, 1 month ago

Working content > Newton's Laws > Newton's Second Law

 

Prerequisites

 

Newton's second law can be represented as a pair of differential equations:  the rate of change of the position is the velocity, and the rate of change of the velocity (the acceleration) is determined by the net force divided by the mass.

Since we know that derivatives can help us predict the future by using them as stepping rules, let's see if we can use Newton 2 as a stepping rule to figure out how something is going to move.

 

In general, when we use a derivative as a stepping rule, we start on one side of the time interval and step to the end. Here's what it looks like for a general function of x, f (x), when the derivative is given by a function g(x):

For the two derivatives of Newton's second law we have to do this for each one.

 

Now the velocity in the left set of equations depends on time and the forces in the right set of equations can depend on position and velocity which depend on time.  The analog to what we did for the general derivative is to evaluate everything on the left at the initial time.  It turns out that while this is usually OK, for cases where our object is oscillating back and forth, the small errors in each step tend to add rather than cancel so the solution goes astray after a little while.  Some fancier math shows that if one steps the velocity equation first rather than stepping the position equation, and then puts the new velocity into the position equation, things work better.  So here is our final stepping rule for solving a motion governed by Newton's second law along one dimension. Starting at time t1 with position x1 and velocity v1, here's how to predict the position x2 and the velocity v2 at a later time, t2 = t1 + dt.

 

You can read off what it means conceptually.  Here's the process.

  1. We start at some time (t1) knowing the position and velocity (x1 and v1).
  2. We figure out the net force at that instant (which might depend on the position or the velocity or both).
  3. The acceleration is the net force divided by the mass of the object being considered. The change in velocity is the acceleration times the time interval.  This yields the velocity, v2, at the later time, t2 = t1 + dt.
  4. The change in position is the velocity times the time interval.  This yields the position, x2 at the later time, t2.
  5. We can now take t2 as our initial time and repeat the process, making a prediction for how the object will move in response to the forces it feels.

 

To see how to set this up on a spreadsheet and do this kind of calculation for yourself, see the follow-on page.

 

Follow-on

 

 

Joe Redish 9/17/11

Comments (0)

You don't have permission to comment on this page.